Step by Step Tutorial : How to integrate SCOM 2012 R2 with SCVMM 2012 R2

Integrating SCOM 2012 R2 with SCVMM 2012 R2 is pretty easy. There are a few important pre-requesties that needs attention. All the needed articles to integrate SCOM 2012 R2 with SCVMM 2012 R2 are mentioned below in the references section of this tutorial. Steps : 1) You can connect Virtual Machine Manager (VMM) with Operations…

0

How to rename a Failover Cluster in Virtual Machine Manager 2012 R2

Problem Description : In case of you renamed a Failover Cluster in Failover Cluster Manager which is connected to a SCVMM 2012 R2 you will see that the renaming will not be reflected in SCVMM 2012 R2. Solution : Under these circumstances you can basically rename the Failover Cluster over the VirtualManagerDB > dbo.tbl_ADHC_HostCluster >…

0

After configuring VM properties in SCVMM 2012 R2 you can receive the following error message. VMM is unable to process one or more of the provided cmdlet parameters. ID 1600.

Problem Description : After configuring VM properties in SCVMM 2012 R2 you can receive the following error message when you try to apply the settings. VMM is unable to process one or more of the provided cmdlet parameters. Type Get-Help Set-SCVirtualMachine -full to view a list of defined parameters and complete descriptions. Then try the…

0

Virtual Machine Manager 2012 R2 may show CPU Average of Virtual Machines [VM’s] as 0 % percent.

Problem Description : Virtual Machine Manager 2012 R2 may show CPU Average of Virtual Machines [VM’s] as 0 % percent. This problem can caused by the Hyper-V Nodes, VM’s and also from the VMM Server itself therefore to not spend to much time with troubleshooting this problem I would suggest to rebuild the base performance…

0