Implicit casting in DataRepeater not working in certain scenarios after SP1

Problem Using the following VB-syntax in a DataRepeater will no longer work after applying .NET Framework 2.0 Service Pack 1 in a medium-trust environment. <asp:Repeater ID=”Repeater1″ runat=”server”>        <ItemTemplate>               <%#Container.DataItem(“data”)%><br />        </ItemTemplate></asp:Repeater>   Resolution Use Eval-method, as recommended in all Microsoft documentation. Using explicit casting would work as well, but you’d have to re-write every page…

2

Using WinDbg – Advanced commands

Did you know you can build your own advanced commands using for each, if, etc? The complete list of control tokens are: .if .else .elseif .foreach .for .while .do .break .continue .catch .leave .printf .block Using these command tokes you can send quite advanced instructions to the debugger that not only will make your job…

11

Exceptions

Introduction This was originally intended to be a post on identifying and troubleshooting Exceptions using windbg. As I started writing I thought I should write a little something about exceptions in general, just to begin the post. That little something grew to be quite big and all of a sudden it was by all means…

3