MIM WAL–Installation Guide Part 2


 

This post is a continuation of  MIM WAL–Installation Guide Part 1

Navigate to the location where you have the MIM WAL Source Code

image

Open the Folder “ReferencedAssemblies”

In this Folder we want to copy the System.Management.Automation.dll file

Once the file is copied into this folder

image

Now open the folder “4.1.3496.0”

Now copy the following .DLL Files into the 4.1.3496.0 folder

  • Microsoft.IdentityManagement.WebUI.Controls.dll
  • Microsoft.IdentityManagement.WFExtensionInterfaces.dll
  • Microsoft.ResourceManagement.dll
  • Microsoft.ResourceManagement.WorkflowContract.dll

image

Now step back a few folders

image

open the Scripts Folder and copy the Files gacutil.exe and sn.exe into the Scripts folder.

image

Open up Visual Studios Command Prompt and enter cd <enter path of location where you have the other copied files>

image

Now that we have all the files required to compile the MIM WAL open up Visual Studios or you can just navigate to the MIM WAL Source Files that you downloaded previously and click on WAL.sln

At the time of Blog Posting Visual Studios 2017 was not supported, so I had to use 2015

Once you have the solution open

lets replace the current snk that is associated with the Source Code

In Visual Studios in the Solution Explorer you will see 3 locations where WAL.snk already exist

image image image

 

Right click on the 1st WAL.snk you find under the Solution ‘WAl’(1 project) section

Right click on the file and select Remove

Now Right click on Solution ‘WAl’(1 project) and select Add

Than select Existing Item

Navigate to location where the new .SNK file you created exist.

you may get a warning message, accept the warning and continue

Repeat these steps for the remaining 2 WAL.snk files

Right Click on WorkflowActivityLibrary and click on properties than select signing

for choose strong name key file browse to the location where the new .snk file is located and select the new one. (note : The old one may still show up)

Uncheck Delay sign only

image

Right Click on WorkflowActivityLibrary.UI and click on properties than select signing

image

for choose strong name key file browse to the location where the new .snk file is located and select the new one. (note : The old one may still show up)

Uncheck Delay sign only

In Visual Studios Change Debug to Release

image

 

Now click on Build

image

And select Build Solution

Look in the output window

image

And verify that it either says Build or Rebuild All and it shows successful.

Navigate to the Location where your WAL Source Code is Located and copy the folder Solution Output

image

Place the Solution Folder on a shared drive or a location you have easy access to.

Continue to MIM WAL – Installation Guide Part 3

 

Comments (0)

Skip to main content